FileZerver release V04.00.02 is now available for download for
firmware update of Cyclone 2+ boards using the admin "Firmware
Update" web page, ZerverView, or FTP, in file fzi0402.bin.

This release can only be used on Cyclone 2+ boards, with 8MB of
flash memory.  The older Cyclone 2 boards have only 4MB of flash.


Major Changes for V04.00.02 --

New options have been added for SmartMirror, using a more recent
release of rsync (2.5.7).

Options added to the admin web pages --

SmartMirror client tasks are allowed to run one a time, so that the
status page for the "current" or "most recent" task makes sense.
A field has been added for each task to set the "Maximum Minutes to
Wait" for the ending of other SmartMirror tasks.  Previously, if a
SmartMirror task had been running when a second task was scheduled
to start, the second task would fail to begin with an error message.

Note that the exclusive use of the admin web page status display
only applies to client operations -- scheduled SmartMirror tasks or
those manually started.  Server operations, in which a FileZerver
responds to an rsync client such as another FileZerver (or even the
same FileZerver), are not affected and (if enabled) can occur at
any time.  SmartMirror server operations can be checked with the
"Server Status" "User Login History" display, in which "RSYNC"
Server access will be listed.

After successful completion of a SmartMirror task, a successor-task
can be immediately started.  This successor-task might involve
the same remote host or a different one, the same directory of
data or a different one, the same direction -- pull or push --
or a different one.  Chains of SmartMirror tasks can be created.

To monitor the success or failure of a SmartMirror task, an e-mail
alert can be used.  For each task, you can select any or all of the
conditions for an alert -- (1) at the beginning of a SmartMirror
task, (2) if a SmartMirror task cannot begin because the rsync
client lock could not be obtained within the Max Minutes to wait,
(3) if a SmartMirror task ends with a problem status, (4) if a
SmartMirror task ends with no problem.  The e-mail will be sent
to one or more recipients as selected on the "System Settings"
"Email Alerts" web page.

To increase the usefulness of the Email Alert facility for
SmartMirror and for other alert conditions, you can now specify how
the "From:" field should appear.  This may be needed to get through
certain mail handler checks, in which the validity of the return
address might be judged in various ways, looking for an opportunity
to discard junk mail.  Specifying the "From:" field may also help
a recipient catagorize the generated messages.